Owner manual

Setting Up the DWDM Passive Component Test System
DWDM Passive Component Test System 55
Identifying the Current DUT
Two buttons are available on the right side of the window to enter and view
additional information about the DUT.
³ Show Limits: This button will open the Optical Port Limits window
(see figure below), where you can see different limits of the current
DUT. These parameters were set in Supervisor level on the DUT
Configuration window. For more details, see Definitions and
Calculation Methods on page 405 or Configuring DUT Parameters for
Pass/Fail Analysis on page 37.
³ Additional Comments: This button will open a text window, where
you can enter additional comments about the current DUT.