Owner manual

Using the Wavelength Calibration Software

DWDM Passive Component Test System 145

Using Calibration Tools

There are two ways to access this step:

³ By clicking Tools during the first step.

³ By carrying out the entire process.

³ Apply New: writes the new calibration constants found for the

IQS-9401 WRM module and displays a calibration certificate. For more

information on the calibration certificate, see Viewing and Printing a

Calibration Certificate on page 146. However, if the whole process is

not performed, you will not be able to access the Apply New button

because no calibration constants have been found.

³ Apply Old: Accessible even if the whole calibration process is not

performed. It re-writes calibration constants, by applying an old

calibration file or the Factory Default.

³ Save Current: Accessible even if the whole calibration process is not

performed. It allows you to save the current calibration constants to a

binary file identified with the following format name:

SerialNumber-Date-Hour.dat.