User guide

Using the IQ-200 Optical Test System

40 IQ-200

Removing Modules from the IQ-203 or IQ-206

CAUTION

Never remove a module while the IQ-203 Control Unit or the IQ-206

Expansion Unit is powered on. This will result in immediate and

irreparable damage to the module and the IQ-203 or IQ-206.

Depending on the locking system with which the module is designed,

there are two ways to remove an IQ module from the IQ-203 Control Unit

or IQ-206 Expansion Unit.

1. Exit the IQ-200 Software and power off the IQ-203 and IQ-206. If you are

controlling modules from a PC, you do not need to turn the PC off.

2. Place your fingers under the module front panel.

Push up the locking mechanism under the module front panel,

as shown below.

3. Firmly pull the module outward.

4. Put one of the supplied protective covers over the empty slot to prevent

dust from entering the module housing.

Locking

mechanism