User guide

Using the IQ-200 Optical Test System

Optical Test System 39

Inserting Modules in the IQ-203 or IQ-206

CAUTION

Never insert a module while the IQ-203 Control Unit or IQ-206

Expansion Card is powered on. This will result in immediate and

irreparable damage to the module and the IQ-203 or IQ-206.

To insert an IQ module in the IQ-200 Optical Test System,

1. Exit the IQ-200 Software and power off the IQ-203 and IQ-206. If you are

controlling modules from a PC, you do not need to turn the PC off.

2. Remove the protective cover of any unused module slot, by pulling the

bottom of the cover and removing it completely.

3. Insert the IQ module into the empty slot. The IQ-203 or IQ-206 will

automatically recognize which slot you selected.

IMPORTANT

Be sure to insert the module all the way to the back of the IQ-203 or

IQ-206 so that the backplane connectors are properly mated. The

module is correctly inserted when its front panel is flush with the

IQ-203 or IQ-206 front panel.

Bottom of

protective cover