User guide

Installing and Configuring the IQ-200 Software
32 IQ-200
Configuring the IQ-200 Drivers
The hardware equipment (IQ-203 Control Unit or IQ-206 Expansion
Card) should be automatically detected.
IMPORTANT
When running on an IQ-203 Control Unit, the IQ-200 Software
automatically configures itself to the default settings. In this case,
you should not change the parameters in the IQ Configuration Tool.
3. If you are using an ISA expansion card, ensure that the parameters in
the ISA Expansion Card Settings group box match the I/O address
range and IRQ you have previously set on the card itself. The DIP switch
illustration adapts to your choices.
4. If you plan to use a GPIB device card, check the Use GPIB Interface box
and specify the I/O Adress Range and the IRQ to use.
5. Click on OK to accept the changes and exit the IQ Configuration Tool,
or click on Cancel to exit without applying the changes.
6. Restart your system to make the changes effective.