User guide

Installing and Configuring the IQ-200 Software

Optical Test System 31

Configuring the IQ-200 Drivers

When running on a PC, the IQ-200 Software must match the configuration

of the IQ-206 Expansion Card. The configuration utility allows you to set the

IQ-200 Software drivers to the correct IRQ and base I/O address (ISA

expansion card only) and to set the GPIB card parameters.

IMPORTANT

For the IQ-200 Optical Test System to function properly, it is important

that no other device use the same IRQ and base I/O address.

The IQ-200 Software is configured through a small utility automatically

accessed at the end of the IQ-200 Software installation. You can also access

this utility at any time after the installation.

To configure the IQ-200 drivers with the IQ Configuration Tool,

1. Open the IQ Settings dialog box (shown below) by double-clicking on

the IQ Settings icon at the bottom of the main window.

2. In the Hardware section, click on Config to display the IQ Configuration

Tool, as shown below.