User guide

Installing and Connecting the IQ-200 Hardware
20 IQ-200
Installing the IQ-206 Expansion Card
4. Firmly insert the IQ-206 Expansion Card into any appropriate expansion
slot with due care and secure the card in place.
5. Reassemble the computer cover and tightly replace every screw.
6. In the case of a PCI card, turn on the computer and ensure the card is
correctly detected and its driver installed as explained in Adding a PCI
Card in Microsoft Windows on page 23.
7. Install the IQ-200 Software (see Installing the IQ-200 Software on
page 27).
Configuring DIP Switches on ISA Card
Hardware configuration is accomplished through DIP switches on ISA
cards (see figures below). Use these DIP switches to set the I/O port
address and IRQ number of the card so they do not conflict with any other
card or component in your system.
Take note of your DIP switch settings. You will be asked to enter these
settings at the end of the IQ-200 Software installation, so the IQ-200
Software can locate the IQ-206 Expansion Card within the system.
IMPORTANT
When setting DIP switches, the ON position is 0 and the OFF position
is 1.
IMPORTANT
The 6-switch bank must always be configured as shown.
O
N
1
2
3
4
5
6
7
8
1
0
1
0
I/O port address
(switches 1 to 5)
IRQ number
(switches 6 to 8)
O
N
1
2
3
4
56
I/O port address
(switches 1 to 5)
These switches should always
be configured as shown