User guide

Installing and Connecting the IQ-200 Hardware

Optical Test System 19

Installing the IQ-206 Expansion Card

The IQ-206 Expansion Card is available in two models: ISA and PCI. Both

cards provide the same functionality, but the installation procedure is not

exactly the same, as explained below. To determine the type of card you

have, see IQ-206 Expansion Card on page 6.

Minimum PC Requirements

The IQ-206 Expansion Card has a power consumption of less than 200 mA.

The computer that will host the IQ-206 Expansion Card must have the

following configuration:

➤ 486 DX4/75 with 16 MB of RAM (minimum)

➤ one free ISA expansion slot (AT 98-pin bus) or one free PCI slot

➤ Microsoft Windows 95/98 (other versions may not be supported)

➤ CD-ROM drive (local or via network)

Installing an ISA or PCI Card

To install the IQ-206 Expansion Card in a computer,

1. If you have an ISA card, set the DIP switches on the card as explained

in Configuring DIP Switches on ISA Card on page 20.

Note: PCI cards are plug-and-play and require no DIP switch setting.

2. Power off the computer and unplug the AC cord.

3. Refer to the computer instruction manual to properly disassemble

the computer cover and access the expansion slots.

IMPORTANT

Handle the IQ-206 Expansion Card as explained in Electrostatic

Discharge Precautions on page 10.