Owner manual

Signal Test
Copper and xDSL Tests 229
TX/RX Tone Test
The page displays the following parameters:
 Edit Parameters button opens a new page that allows you to set the
test parameters.
 Test Status displays the current state of measurement or an error
message.
Setting Test Parameters
The Test Parameters page allows you to set the parameter values for the
test.
To set the Parameter values:
1. From the Copper main menu Test Groups, select Signal test
.
2. From the Tests menu, select TX/RX Tone test.
3. Tap Send Tone tab for which you want to set the Parameter values.
4. Tap Edit Parameter button to open the Test Parameter page.
5. Set the Parameter values as required.
6. Tap Close to confirm and exit the page.