Owner manual

Signal Test
Copper and xDSL Tests 225
WB Attenuation Test
Setting Threshold Values
The Test Thresholds page allows you to set the WB Attenuation
Thresholds values for the test.
To set the Threshold values:
1. From the Copper main menu Test Groups, select Signal test
.
2. From the Tests menu, select WB Attenuation test.
3. Tap Edit Thresholds button to open the Test Thresholds page.
4. Set the threshold values as required.
5. Tap Close to confirm and exit the page.
The page allows you to set the following parameters:
Threshold is the threshold limit for each pair: Maximum, Minimum, or
None.
Attenuation sets the threshold.