Owner's manual

Setting Up the Instrument in EDFA Mode
204 FTB-5240S/S-P/BP
Defining Preferences
3. Under System and link information, define the following parameters
as needed:
 Link ID prefix: prefix value for the link ID. You can enter any
alphanumeric value.
 Starting value: suffix increment starting value for the link ID.
This value is incremented each time a new file is saved provided
the Auto Increment option is selected.
 Orientation: orientation of the link.
 System: information about the system under test.
4. Under Location Information, define the following parameters as
needed:
 Network element: type of network element.
 Test point: where the test is performed on the link
 Description: Enter the description of location if required.
5. Press OK to save the changes and close the window, or press Cancel to
exit without saving.
Press Restore Defaults to remove all the changes and apply the default
values.
IMPORTANT
When the Auto Increment option is not selected, while saving the
trace file, you have to manually change the file name, else the
application will overwrite the previously saved files every time you
save a new trace.