Owner`s manual

Step 3
Connect the Incline Buttons and Hand Pulse Sensor with Wires (62) from the
Right Handlebar (85R) to the Pulse Extension Wire (100) and Control Button
Extension Wire (101) from the right side of the Handlebar Support Tube Frame
(75). Then connect the Right Handlebar (85R) to the right side of the
Handlebar Support Tube Frame (75) by inserting the Right Handlebar (85R)
onto the right side of the Handlebar Support Tube Frame (75), using two
M8x16mm Bolts (32) and two M8 Spring Washers (73). Tighten bolts with the
5M Allen Wrench with Phillips Screwdriver provided.
Connect the Speed Buttons and Hand Pulse Sensor with Wires (63) from the
Left Handlebar (85L) to the Pulse Extension Wire (100) and Control Button
Extension Wire (101) from the left side of the Handlebar Support Tube Frame
(75). Then connect the Left Handlebar (85L) to the left side of the Handlebar
Support Tube Frame (75) by inserting the Left Handlebar (85L) onto the left side
of the Handlebar Support Tube Frame (75), using two M8x16mm Bolts (32) and
two M8 Spring Washers (73). Tighten bolts with the 5M Allen Wrench with
Phillips Screwdriver provided.
IMPORTANT: While sliding both Right/Left Handlebars (85R/85L) onto the
Handlebar Support Tube Frame (75), make sure the wires are installed inside
the tubes and take care not to pinch the wires.
Tool: Hardware:
ASSEMBLY
14
63
32
100
101
73
100
101
75
62
73
32
85R
85L
Allen Wrench with
Phillips Screwdriver 5M
(32) Bolt (M8x16mm)
4 PCS
(73) Spring Washer (M8)
4 PCS