Use and Care Manual
50-PIECE AIR TOOL KIT
F2
31
AIR HAMMER
C3
32
NOTE: This tool features an exhaust
deflector (F2) 9 which can be rotated to
any position to direct air away from
workpiece or operator. (See Figure 31)
1. Hold the tool firmly with both hands. Bring the
tool towards the workpiece at an angle of
60-70 degrees approximately.
2. Press the trigger (C3) slowly with the chisel in
light contact with the workpiece. (See Figure 32)
3. Slowly move the chisel across the workpiece
surface.
NOTE: When removing scale, rust or
other contaminants, you only need to
apply a light force on the tool.
NOTE: Keep the chisel contacting the
workpiece while you are releasing the
trigger to stop operation. The tool may
impact briefly after the trigger is
released.
1/4" AIR DIE GRINDER
Push lever (F4) forward and press down on the
trigger (E4) to start the tool (A4). (See Figure 33)
A4
E4
F4
33
21