User's Guide

www.excelsecu.com
Ver.
1.0
4.4 Connect ESPT-100 with WIFI
1. Download the Windows drivers on the following website:
https://www.excelsecu.com.cn, then install the drivers(the same drivers for USB).
2. Make sure the power switch of ESPT-100 is off,connect the computer and
ESPT-100 with the USB type-C cable.
3. Make sure there is paper roll in ESPT-100 then turn on the power switch.
4. Download the APP on the following website: https://www.excelsecu.com.cn,
then install it.
5. Press the Fn. botton of ESPT-100 for 3 seconds then release it,check the
STATUS- LED(Blue) to flash slowly(once per second).
6. Open the APP and find the ESPT-100.Configure the name and password of the
network and wait for few seconds.
7. If the name and password of the network is correct,the IP address will be shown
in 45 seconds.
8. Repeat the 5-7 steps if the network is incorrect.
9. Open the driver installation file,fill in the IP address of ESPT-100 and an
operation test can be performed.
4.5 Connect ESPT-100 with Bluetooth
1. Make sure there is paper roll in ESPT-100,turn on the power switch,press the Fn.
botton of ESPT-100 for 6 seconds,then release it.Check the STATUS- LED(Blue)
to flash fastly(twice per second).
2. The information include the device name of the bluetooth will be printer.
3. Trun on the bluetooth of PC,tablet or phone,select the displayed device
name(ESPT-100 xxxxx).
4. When pairing is completed,the displayed device name will be displayed in the
bluetooth list.
5. If pairing is not completed in 100 seconds,repeat 1-4 steps again.