Operation Manual

11- ENG
A12335
8. Start engine. See Engine
Owners Manual for correct
procedure. NOTE: When engine
r
ope is pulled, pressure starts
building in the gun. If the engine
does not start after two pulls,
pull the gun trigger to r
elieve this
pressure.
9. Depress trigger on gun to
start water flow. NOTE: Stand
on a stable surface and grip
gun/spray wand firmly with both
hands. Expect the gun to kick
when trigger
ed.
10. Release trigger to stop water
flow.
11. Adjust nozzle spray for the
task being performed. See How
To Use Wand instructions in this
s
ection.
SHUTTING DOWN
1. After each use, if you have
applied chemicals, place chemical
hose into container of clean water
and draw clean water through
chemical injection system to rinse
system thoroughly. NOTE: Failure
to do so could cause damage to
the pump.
2.
Turn engine off. See Engine
Owner’
s Manual. NOTE: NEVER
tur
n the water off with the engine
running.
3.
Turn water source off.
4. Pull trigger on spray gun to
r
elieve any water pressure in hose
or spray gun.
5.
See Storage section in this
manual for pr
oper storage
procedures.