Troubleshooting guide

7 - ENG

ASSEMBLY INSTRUCTIONS (CONT.)

• SAVE ALL INSTRUCTIONS

4. Locate axle and slide axle through holes in frame.

Secure one wheel to each end of axle with supplied M8

nuts. Ensure that small plastic washer is placed

between frame and wheel. Tighten nuts with provided

wrench.

5. Remove M8 bolts from upper handle and attach panel

to upper handle with M8 bolts. Tighten with Allen

wrench provided.

6. Remove screws from lower frame assembly and

attach wand holder to frame assembly with these

supplied screws.

7. Roll unit off of carton and discard carton.

8. Connect high-pressure hose to pump inlet. (Fig. 4)

9. Connect wand to gun and tighten securely. (Fig. 5)

10. Attach high-pressure hose to gun. Tighten securely.

(Fig. 6)

NOTE: The pump on this unit is maintenance free and

requires no oil, if there is a problem with the pump contact

an Authorized Service Center.

FIG. 4

FIG. 5

FIG. 6