Specifications

PLATFORM
Capacity: 10,000, 30,000, 60,000 (standard),80,000 Ibs/
5,000, 15,000, 30,000 (standard), 40,000 kg
Overall Dimensions:
• W
ith Readout Assembly: (standard)
34 L x 33.5 W x 4 H in/864 L x 851 W x 102 H mm
• Without Readout Assembly:
34L x 28W x 4H in/864L x 711W x 102 H mm
Active Weighing Surface: 30 L x 24 W in/762 L x 610 W mm
Weight: 140 Ibs/64 kg
Construction: Aluminum
Overload: 150%
TWO STAGE RAMPS
Assembled: 78 L x 24 W in/1,981 L x 610 W mm
Weight: 70 Ibs/32 kg
Entry Ramp: 46 L x 24 W in/1,168 L x 610 W mm
Weight: 32 Ibs/14.5 kg
Secondary Ramp: 32 L x 24 W in/813 L x 610 W mm
Weight: 38 Ibs/17 kg
Slope: 3°
AXLE SPACER
Dimensions: 25.5 L x 24 W x 4 H in/648 L x 610 W x 102 H mm
(length may vary due to different landing gear dimensions)
Weight: 40 Ibs/18 kg
TIRE STOP
Dimensions: 8 L x 24 W x 1O H in/203 L x 610 W x 254 H mm
Weight: 20 Ibs/9 kg
TRANSPORT CART
Dimensions: 121 L x 40 W in/307 L x 101 W cm surface area
Construction: Mild Steel
Wheels: Urethane or Pneumatic (standard) with front swivels
Features: Tow bar with eyelet, forklift tubes, brake and canopy cover
Power: 12 VDC, 120/220 VAC
CONTROLS (Available with self-contained readout assembly)
General: All controls stainless steel, located on waterproof and oil
tight keypad with large contact surfaces for protection
On/Off: Two separate switches for unambiguous operation
Zero: Push button zero checks for motion as per
NIST/OIML requirements
Ib/kg: Sets units of measure
Indicators: Low battery, Ib/kg and error messages
FEATURES
Latitude/Altitude Correction: To correct values (Default 45°)
Calibration:Keypad calibration corrects any out of tolerance condition
Motion Detection: Adjusts for motion or movement on scale to prevent
error in weight reading
Auto Shut Off: Shuts off automatically when not in use to conserve
battery life (variable)
Memory Backup: Retains displayed weight if there is a power loss
Backlight: Automatic sensor illuminates display in low light conditions
Active Weighing Surface
Frame
Display
lb/kg
Zero
On
Off
I/O connector
Charge Lamp
Charge
Battery Cover
Hand
Hold
3.50 IN
89 MM
4.00 IN
102 MM
Note: Platform, ramp and spacer can
be sized to your specifications.
*Pending
AC30-60
™
and AC-Weigh
™
are registered trademarks of Intercomp
®
Specifications subject to change without notice.
Any manufacturer can make claims of quality, service or
technical superiority, but only Intercomp can back such
statements by our experience in providing the industry with
these attributes.
No other manufacturer supplies this fully electronic technology
to more airlines, airframe manufacturers, maintenance centers
or military branches than Intercomp.
We invite you to review our broad customer list which will give
you the comfort and reassurance that you are following the
well scrutinized decisions of the industry’s most experienced,
prestigious and satisfied users.
Our customer base indicates that when the world looks for a
weighing system, one that is built with quality, reliability and
performance - they look to Intercomp.
Basic internal design enhances ease of support and maintenance.
Fully electronic, Federally certified load cells maximize accuracy
and performance.
AC30-60 PLATFORM SCALE SPECIFICATIONS
Platform Side View - beveled edge
for oversized or dual tires
7
OPTIONS:
• Transport Cart
• Transport Case
• AC2000-RF CPU Computer
• ACWeigh Software
• Telemetry
• Infrared
• Remote Battery Charger
• Factory Mutual - Intrinsically Safe
• Hydraulic Jacking System
• Super High Capacity Scale
ELECTRONICS
Accuracy:±O.1% of applied load or ± 1 graduation;
whichever is greater
Circuit Board:CMOS 20 bit ultra high precision A/D converter
with high efficiency microcontroller
NTEP approved 10,000 Division
Transducer Type: NTEP/OIML approved 10,000 Division Shear
Beam Load Cell
Input/Output: RS232 or RS485
Display: 1" in/25 mm L.C.D.
Graduations:1, 2, 5 and 10 Ib/0.5, 1, 2 and 5 kg
(10 lb/5 kg standard)
Power Source Required: 12 VDC, 120/220 VAC
Batteries: 6 “D” size NiCads (standard) or Alkaline
EMI/RFI: Meets Mil-Spec 461 and Euro EMC Directives
ENVIRONMENTAL
Humidity: 5 to 99% Non-condensing
Temperature: Operating: -10° C to 50° C (14° F to 122° F)
Storage: -40° C to 75° C (-40° F to 170° F)