User's Guide

User Guide
- 35 –
18.3.2 When the carriage return character (CR) is received, the S2000 PRO/ELITE
will respond with an error message if there is a problem.
For example:
Error Message Response: “Err67\r”
18.3.3 If there are no errors, the S2000 PRO/ELITE will respond as indicated below.
In the example, the XX presents one byte CRC8 value.
18.4 Command Descriptions:
1. Connect S2000 PRO/ELITE
Command to S2000 PRO/ELITE; CONN
Response from S2000 PRO/ELITE; READY
2. Disconnect S2000 PRO/ELITE
Command to S2000 PRO/ELITE; DCON
Response from S2000 PRO/ELITE; CLOSE
3. Lock the front panel
Command to S2000 PRO/ELITE; LOC
Response from S2000 PRO/ELITE; Received
4. Unlock the front panel
Command to S2000 PRO/ELITE; ULOC
Response from S2000 PRO/ELITE; Received
5. Clear Alarm
Command to S2000 PRO/ELITE; CLR
Response from S2000 PRO/ELITE; Received
6. Get unit status
Command to S2000 PRO/ELITE; GUS
Response from S2000 PRO/ELITE; n (n represents a integer
number)
Example:
Note: The command “CONN18\r” must be sent out first to establish
communication with the connected PC. If a “READY0A\r” is received from
the S2000 PRO/ELITE, communications can commence with the unit,
otherwise, the command “CONN18\r” should be resent until the response
“READYOA\r” is received.