User's Guide

User Guide
- 31 –
13.3 Radiometer RS-232 Phono Connector: Signal Descriptions
13.3.1 The front panel RS-232 stereo phono connector is labelled “Radiometer”. This
connector is used to connect S2000 PRO/ELITE to the R2000 Radiometer for
calibration and setup purposes. It is a RS-232 connector dedicated to
communication with the R2000 Radiometer.
PIN NO
SIGNAL NAME
1 (Shield)
GND
2 (Ring)
Tx
3 (Tip)
Rx
Table 3 RS-232 Phono-Connector Pin-Out
13.4 Audio Style Foot Pedal Connector: Signal Descriptions
13.4.1 The rear panel foot pedal connector, a 3 mm audio style jack, has the following
pin-out:
Connection Point
SIGNAL NAME
Outer Rim
Positive input, active low
Center Pin
Common ground (GND)
Table 4 Foot Pedal Pin-Out
13.4.2 This is a simple 2-wire, audio style jack that can be connected to a foot pedal
(supplied with each unit) or any other electro-mechanical triggering device. This
is an exposure trigger input used to start an exposure. The shutter activation
input and front panel START/STOP button will also trigger the shutter.
14 Viewing the Accumulated Lamp Hours
14.1.1 Your S2000 PRO/ELITE system automatically accumulates the number of
hours that the lamp is on and shows this information on the LCD display.
14.1.2 Navigating to Info/Lamp Info to view this information