User's Guide

User Guide
- 22 –
10.1.2 - Blank -
10.1.3 - Blank -
10.1.4
10.1.5 Blank
10.1.6 Blank
10.1.7 For any setting at 99% or less, the S2000 PRO/ELITE will record the optical
output intensity using internal sensors for the Closed-Loop Feedback circuit.
Each subsequent exposure will automatically generate the same optical output
intensity, even as the lamp ages. As a result of lamp aging, subsequent
exposures may display a higher iris open percentage value; however, the
output intensity will be consistent with the original setting (+/-5% or
200mW/cm2, whichever is greater).
10.2 Adjusting the Light Output in the Absolute Mode
10.2.1 Blank
Note: While in Level Mode, pressing the start/stop button will manually
open the shutter until the start/stop button is pressed again to close
the shutter. The timer function will not be activated.
Note: The shutter must be in the open position to make adjustments to the iris
position.
Note 1: The S2000 PRO/ELITE must be calibrated using the R2000
Radiometer.
Note 2: Removing the light guide at any time from the front panel light
guide port will require re-calibration of the S2000 PRO/ELITE.
Note: Closed Loop Feedback shut-off @exposure time of .3 sec and
lower.