User's Guide

User Guide
- 16 –
6.1.8 Ensure the lamp anode cooling fin (bar) and lamp power lead, at the front of
the lamp, are centered within the lamp holder cut out. Rotate the lamp as
required.
6.1.9 Replace the lamp housing side panel and tighten the fastening screw.
Note 1: if the lamp housing panel is not secured completely the lamp will
not strike and the system will not turn on.
Note 2: if the wrong type of lamp has been installed in your unit, a
message will appear on the LCD display. Refer to section 22 for
troubleshooting information.