ThinAir2015TechSheet

ThinAir
®
HAND DRYER
TECHNICAL DATA SHEET
EXCEL DRYER, Inc. Phone [phone] [e-mail]
East Longmeadow, MA Fax [phone] www.exceldryer.com
2015
DECEMBER
PERFORMANCE
A. Dry Time: 15 Seconds
*
B. Wattage: 950 Watts (Heat On) - 300 Watts (Heat Off)
C. Certifications:
CONSTRUCTION
A. All covers will be fastened to a base plate by one chrome plated
tamper-proof bolt.
The cover shall be composed of:
ABS – White polymer with SanaFor
TM
antimicrobial additive.
B. Base plate shall be equipped with (3) 7/8" (22 mm) diameter knockouts,
one of which is located on the right side and suitable for use with
surface conduit.
C. All internal parts shall be coated according to Underwriters'
Laboratories, Inc. requirements.
D. Entire mechanism shall be internally grounded, per UL requirements.
E. Accessories (optional)
MICROBAN
®
Antimicrobial Wall Guards:
89W (White), 89B (Black), 89S (Stainless)
MECHANISM
A. Motor shall be a thermally protected, series commutated, through-flow
discharge vacuum motor/blower (~½ hp / high-30,000 rpm, low-20,000
rpm) which provides air velocity of up to 16,000 LFM (linear feet per
minute) at the air outlet.
B. Heating element (550 W) is constructed of Nichrome wire and mounted
inside the blower housing behind air baffle, thereby being vandal resistant.
It shall be protected by an automatic resetting thermostat, which shall open
whenever air flow is cut off and shall close when flow of air is resumed.
It shall produce an air temperature of up to 141°F (61°C) at a 72°F (22°C)
ambient room temperature at the outlet and 101°F (38°C) at the hands (4
inches [102 mm] below air outlet).
C. Control assembly is activated by an infrared optical sensor located next to
the air outlet. The dryer shall operate as long as hands are under the air
outlet. Control includes a speed and sound control mechanism, variable
heat control with High, Medium, Low and Off settings and a filter sensor
which is activated should the filter become clogged. There is a
35-second lockout feature if hands are not removed. Sensor equipped
with externally visible Red LED light that can flash error codes to assist in
troubleshooting.
LIMITED WARRANTY
The dryer shall be guaranteed to be free from defects for a period of five
(5) years. Warranty shall include labor performed at factory as well as the
repair or exchange of defective parts, at manufacturer's option.
QUANTITY RECOMMENDATIONS
One dryer for every two washbasins is sufficient for most applications. If
restroom traffic is unusually heavy, we suggest one dryer per washbasin in small
installations and two dryers for every three washbasins in larger installations.
When a 54" washfountain is used, we suggest four to five dryers.
Job Name Date
Model Specified Quantity
Voltage Specified
Customer/Wholesaler
Contractor
Architect
FOR ARCHITECT/ENGINEER APPROVAL
RoHS
TA-ABS
White Polymer (ABS)
MODELS: TA -
ABS
-VOLTAGE (See Chart)
ADA COMPLIANCE
ADA guidelines state that fixtures mounted above 27"
must not protrude more than 4" from the wall.
4"
37"
Maximum: 48"
Recommended: 37"