model no.
PARTS LIST #1 Wire Shelf 3 #2 Post 4 #3 Split Sleeve 24 #4 Feet Leveler 4 #5 Swivel Caster 2 #6 Swivel Caster With Lock 2 1 3 2 5 4 6 Tools needed for Assembly Wrench ( 1/2 inch ) Rubber Mallet
ASSEMBLY INSTRUCTIONS Step 1 (Stationary Option) Screw the feet leveler (#4) into the bottom of each post (#2), turn each leveler clockwise until in place. High Low Note: Adjust the feet levelers to level the shelving unit. Step 1 (Mobile Option) Screw each caster (#5 & #6) into the bottom of each post (#2), turn each caster clockwise until in place. Use the provided wrench to tighten all the way. Make sure the casters with lock (#6) are on the same side.
ASSEMBLY INSTRUCTIONS 3 058-1362-6 Step 3 Lay the product carton flat on the ground. Place the shelf (#1) on its side and onto the carton to protect the finish. Insert all four posts (#2) into the shelf corner cylinders as shown in the below diagram. Step 4 Place the unit into an upright position. Push down the shelf (#1) to make sure it sits securely onto the split sleeves (#3). Gently tap the shelf (#1) if necessary. Step 5 Repeat the above steps to add the remaining shelves.
4 SATETY WARNINGS Read and follow all instructions before using this product INSPECT this product before use. Do not use the product if you notice loose or damage parts. ASSEMBLE and use the shelf on a flat, level, solid surface that is capable of supporting the weight of the cart and parts. LOAD the shelf from the bottom up. Failure to load from the bottom up may cause the product to tip, which could cause personal injury and product damage.
