User's Manual

USING THE SAFEPRESENCE MOTION DETECTOR
TESTING
Sensor Set Up
The alarm/chime may not be activated by waving a hand in front of the unit. Test by simulating use.
To Test:
1. Turn sensor on by selecting “CHIME” or
“REMOTE” on the sensor.
2. Turn chime on.
3. Simulate intended use of the system
(ie. walk through the door, get up from bed).
4. Alarm/chime will sound.
Test Range:
1. Turn sensor on.
2. Turn chime on.
3. Wait 10 – 60 seconds.
4. Walk or move in and around sensor area.
5. The chime/alarm will not sound if you walk
beyond detection range.
6. Adjust location or angle of sensor.
SETTING THE CODE
Using multiple sensor and/or pagers can create interference in the detection system and affect system
operation. Alarms may not be heard. Test a multiple sensor and/or pager set up before use.
The SafePresence sensors and pagers each
have a code switch that is located inside the
battery compartment. The pins of code switch
are pre-set at the same direction at the factory
and matches one sensor to one pager.
By changing the code, caregivers are able to
use multiple sensor and/or multiple pagers. For
example, one pager may be used to receive
alarms from one or more sensors.
To use more than one sensor or pager, contact
your distributor.
For assistance call your distributor or visit www.safepresence.com
SafePresence™ is a trademark of J. Brasch Co. or its affi liates.
All Rights Reserved © 2011 DOC 16.71100.12
READ and follow these instructions. SAVE them for future use.
7
PREPARATION
PACKAGE CONTENTS
When you receive your SafePresence Motion Detector blister pack inspect the contents.
Your blister pack should include:
1. Sensor.
2. Pager.
3. Screws for mounting.
4. Set of Instructions.
The sensor and pager each require a 9 volt alkaline battery for operation. Batteries are not included.
Check the contents immediately. If any items are missing from the box, please contact your distributor.
Read these instructions and put them in a safe place for future use, along with a record of all training.
All caregivers using the motion detector should read and follow these instructions.
Call your distributor or visit www.safepresence.com for information on the motion detector.
PRODUCT DIAGRAMS AND FUNCTIONS
For assistance call your distributor or visit www.safepresence.com
SafePresence™ is a trademark of J. Brasch Co. or its affi liates.
All Rights Reserved © 2011 DOC 16.71100.12
READ and follow these instructions. SAVE them for future use.
4