User's Manual

IMPORTANT SAFETY INSTRUCTIONS
SERVICE
1. Only qualifi ed personnel can perform repairs on the SafePresence Motion Detector. Attempting to repair the unit
yourself or by someone other than an authorized representative may damage the unit and will void the
manufacturer’s warranty. Discontinue use and contact your distributor if any of the following situations occur:
Liquid has been spilled or objects have fallen onto the sensor or pager
The sensor or pager has been exposed to rain or water
The sensor or pager are very hot to the touch
The Motion Sensor does not operate normally by following the instructions in this instruction manual
The SafePresence Motion Detection or accessories exhibit a change in performance
INTERFERENCE / RANGE
The Motion Sensor system and accessories operate on 433 Mhz (approximately). The optimum range between the
sensor and pager 50 feet (15m) but range is affected by the operating environment in healthcare facilities as well as
the home setting. Test the sensor and pager daily and before each use.
TEST THE SENSOR AND PAGER DAILY AND BEFORE EACH USE.
TEST THE SENSOR AND PAGER EACH TIME BATTERIES ARE REPLACED. Proper use of this system
requires ongoing testing.
TEST THE SENSOR AND CHIME DAILY AND WHENEVER THERE IS A CHANGE IN THE OPERATING
ENVIRONMENT (ie. the addition of phones, washers, dryers, microwaves, computers, refrigerators,
computers, and other electrical equipment).
1. Place the SafePresence Motion Detector away from electrical appliances such as:
Electric Blankets Fluorescent Lamps and Motors Televisions
Computers Phone Systems Electrical Equipment
Ham Radios
2. Keep components free from smoke, dust, direct sunlight, heat sources such as heaters and cooking apparatus,
high temperatures, damp basements, and vibration.
3. Communications between the sensor and pager may be impaired by metal or steel objects.
4. Inspect sensor and pager regularly for signs of damage. Contact your distributor for repair.
FCC Part 15. This equipment has been tested and found to comply with the limits for a Class B Digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
For assistance call your distributor or visit www.safepresence.com
SafePresence™ is a trademark of J. Brasch Co. or its affi liates.
All Rights Reserved © 2011 DOC 16.71100.12
READ and follow these instructions. SAVE them for future use.
3
USING THE SAFEPRESENCE MOTION DETECTOR
INSTALLING BATTERIES
The sensor and pager each require one 9V battery (not included).
Remove sensor from bracket by gently separating the bracket arms. When replacing, a fi rm click indicates the
sensor is fi rmly in place.
Battery Installation for Either Unit:
1. Locate the battery compartment.
2. Press the arrow on the battery compartment cover.
3. Slide cover open.
4. Insert the battery, snapping it securely into the contacts.
5. Replace the battery cover.
Battery Removal from Either Unit:
1. Locate battery compartment.
2. Press down the arrow on battery compartment cover.
3. Slide cover open.
4. Remove the battery.
5. Dispose battery properly.
AC POWER
Only use SafePresence adapters (sold separately) with the Motion Detector. If other adapters are used, the
system may be damaged. Discontinue use.
An adapter jack is on the SafePresence Pager. The adapter is sold separately. Contact your distributor for more
information.
For assistance call your distributor or visit www.safepresence.com
SafePresence™ is a trademark of J. Brasch Co. or its affi liates.
All Rights Reserved © 2011 DOC 16.71100.12
READ and follow these instructions. SAVE them for future use.
8