User Manual

EXCEL DRYER, INC 1.800.255.9235 EXCELDRYER.COM [e-mail]
357 CHESTNUT STREET, EAST LONGMEADOW, MA 01028
1/2017
2
READ AND SAVE THESE INSTRUCTIONS
WARNING: For proper electrical connections, check your local building codes.
Your unit must be installed by a qualied, licensed electrician.
PRE INSTALLATION WIRING
• Checkthattheelectricalsupplycorrespondstothatshown
 ontheratingstickerofunit.Ifthedryerisconnectedtoany
 electricalsupplyotherthanthatstatedontheratingstickerof
 theunit,permanentdamageorimproper,unsafeoperationof
the unit may result.
• Makesureelectricityisswitchedoffatthemainpanelbefore
 installing,maintainingorcleaningthishanddryer.Dryermust
be installed in accordance with current local wiring and
building regulations.
• Do not wire this hand dryer into the lighting circuit. It must be
protected by an independent circuit.
• Dryer is intended to be permanently connected to power
 supply,andmustbeproperlygrounded.
SAFETY
• Troubleshooting and internal maintenance must be performed
 byqualiedservicepersonnel.
• Do not use any power wash equipment for cleaning on or
near this unit.
• DonotusetheXLERATORdryerfordryinghair.
• Do not obstruct air inlets or outlets.
1. Disconnectthepowersourcepreviouslybroughttothehand
dryerlocation(seepreinstallationwiringabove).
2. UsetheTamper-ProofWrenchsuppliedtoremovethe2
 covermountingscrewsandliftcovertoremovefrombase
plate.
3. Ifelectricalwiringentryistobemadefromtherear,remove
 theappropriatepre-formedknockoutonthebaseplate.If
 entryistobemadefromthebottom,knockoutthe
 pre-formedareaonthecoverforyoursupplyconnection.
 Arigidconduitmustbeused.
4. Selecttheappropriatemountingheightfordryer(Table1)
 andfastener,asrecommended(Table2).Thereshouldbe
 noobstructionbetweenthehanddryerandtheoor.If
 mountingoveracountertop,distancefromcountertodryer
 mustbe15”(381mm)minimum.
CAUTION: Do not use Base Plate as a guide when drilling.
Make sure no pipe work (gas, water, air) or any electrical cables
or wires are located directly behind the area to be drilled.
5. AttachBasePlateatthefourcornerstosmoothwall.
Formostsecureinstallation,use2additionalmountingholes
asshownindrawing.Fornon-HEPAunits,removeControl
Assemblytoaccesstherightsidemountinghole.
ForHEPAunits,removelteronlytoaccesstherightside
mounting hole.
6. Identifythevoltageofyourdryerfromtheratingstickerofthe
unit. Then connect to a dedicated branch circuit not
 exceeding20Amp.
7. Secureelectricalwiringtoterminalsasindicatedbythe
 schematicafxedtoblowerhousing.Anidentiedground
 connectionpointissuppliedontheBasePlateforyour
equipment ground wire. Dryers should be installed per local
code requirements.
8. CarefullyreplaceCoverusingthe2screwspreviously
 removedinstep2.Restorepowerandtestforproper
 operation.Inmultipleinstallations,makesuretheserial
 numbermarkedontheinsidematchesthecovernumber.
9. It is highly recommended that a bead of silicone sealant be
 placedaroundtheoutsideofthecoveratthewalltoprotect
dryer from internal corrosion caused by wash water and
cleaning solutions.
10.ReturnTamper-ProofWrenchtoowner.
SUGGESTED MOUNTING HEIGHT
from oor to bottom of dryer:
Men 45"(114cm)
Women 43"(109cm)
Teenagers 41"(104cm)
SmallChildren 35"(89cm)
Accessible 37"(94cm)
MOUNTING HARDWARE
Recommended Fastener (not supplied):
MasonryWall ½”ExpansionSleevewith¼”LagBolt
HollowWall ¼”WingTypeToggleBolt
WoodenWall ¼”LagScrewWithWasher
1 2
INSTALLATION INSTRUCTIONS
TABLE1 TABLE2
IMPORTANT SAFETY INSTRUCTIONS