Specification Sheet

XLERATOR
®
HAND DRYER
XCHANGER
®
COMBO KIT
40502 Recess Kit, Brushed Stainless Steel $180
(for ADA 4” protrusion requirements)
40550 XChanger, Brushed Stainless Steel $220
(Use with #40502 Recess Kit)
40551 XChanger, Brushed Stainless Steel, ADA height $220
(Use with #40502 Recess Kit)
40575 XChanger Combo Kit: $400
Comes with ADA Recess Kit #40502
and Standard XChanger #40550
40576 ADA XChanger Combo Kit: $400
Comes with ADA Recess Kit #40502
and ADA Height XChanger #40551
XCHANGER SPECIFICATIONS
Weight: 17 Lbs. (7.7 kg)
Overall Dimensions: 17 ¼” wide x 56” high x 1” deep
Rough Wall Opening: XChanger is installed over the footprint of most
common paper towel dispenser/waste receptacles or approximately
17 ¼” wide x 56” high
Installation Guide (Consult local ADA codes):
The XChanger is a retrofitable conversion kit which will enable you to
update your existing paper towel dispenser and waste receptacle to an
XLERATOR hand dryer. Used in conjunction with the Recess Kit, the
XChanger is installed over the footprint of common paper towel dispenser/
waste receptacles designed to match their dimensions so there is little or
no wall repair required once the XChanger kit is installed.
ADA Height XChanger Kit: The XChanger also comes in an ADA version.
The opening to the unit is 7” lower to allow the recess kit and XLERATOR
hand dryer to be ADA compliant. Check local regulations for actual ADA
compliance rules.
CONSTRUCTION
XChanger is fabricated of 18 gauge 18-8 type 304 stainless steel with #4
satin finish. All welded construction.
RECESS KIT SPECIFICATIONS
Width: 16
3
⁄
8
” (416 mm) Height: 26” (660 mm)
Depth: 3
3
⁄
8
” (86 mm) Weight: 11 lbs. (4.99 kgs.)
Installation Guide (Consult local ADA codes):
An ADA-compliant Recess Kit for XLERATOR hand dryer models that
adheres to the 4” protrusion ADA guidelines in a restroom walkway and
helps keep water off the wall and floor. When installed, bottom of hand
dryer will be 10” (254 mm) above bottom of rough wall opening. Therefore,
bottom of rough wall opening should be 10” (254 mm) below suggested
mounting height for hand dryer. (See suggested mounting heights above).
CONSTRUCTION
Wall box is fabricated of 22 GA 18-8 type 304 stainless steel with #4 satin
finish with 16 GA 18-8 type 304 stainless steel dryer mounting plate. All
welded construction.
NATIONAL INSTALLATION SERVICES AVAILABLE
CALL FOR DETAILS 800-255-9235
XCHANGER COMBO KIT
PART #40575 - STANDARD
PART #40576 - ADA
PART #40550 - STANDARD
PART #40551 - ADA
(XLERATOR Hand Dryer not included)
PART #40502
Part ID Description List Price
TIME TO THROW IN THE TOWEL
®
EXCEL DRYER INC • 1.800.255.9235 • EXCELDRYER.COM