Manual

LOADING:
To load the magazine push down the front of the follower with the rim of the cartridge,
then slide the round back under the magazine lips. Repeat until the magazine is loaded
with up to 9 rounds. To unload the magazine, push each cartridge forward until it is no
longer held by the magazine lips.
Load your firearm by keeping your finger off the trigger. Insert the magazine in the Rifle
by pushing it upward into the magazine well until it is retained by the magazine catch.
While keeping the muzzle pointed in a safe direction, hold on to the rifle stock in front of
the trigger guard. Now with your other hand, grasp the bolt handle and pull fully to the
rear then release it promptly allowing it to return on its own. This action will chamber the
first cartridge, cock the hammer and the pistol is ready for firing.
UNLOADING:
Rotate the safety lever up to the “ON” position and remove the magazine by pushing the
magazine catch rearward and pulling the magazine down and out of the grip. Keeping the
Rifle pointed in a safe direction, pull the bolt back fully to eject the cartridge from the
chamber. Holding the bolt back, look in the chamber to ensure the Rifle is empty. To de-
cock your Rifle, BE ABSOLUTLY SURE THE RIFLE IS UNLOADED AND HAS NO
MAGAZINE INSERTED, then pointing the Rifle in a safe direction pull the trigger to
“dry fire” the firearm, now the hammer has been de-cocked.
DISASSEMBLY:
WARNING!
ALWAYS CHECK TO MAKE SURE YOUR RIFLE IS UNLOADED BEFORE
YOU BEGIN TO DISASSEMBLE!
Remove the bolt handle by unscrewing the screw in the center of the handle. Now remove
the two screws on the top of the barrel shroud. Now pull the shroud up and off of the
barrel. Disconnect the recoil spring from the bolt and the barrel. The bolt can now be lifted
up and off the frame. Do not allow the hammer to drop forward when the bolt is removed,
as this may cause damage to internal parts. We suggest that you do not take down this
firearm any further than is explained in this manual.
REASSEMBLY:
WARNING!
Excel Industries, Inc. assumes no liability or responsibility whatsoever for injury, death, or
damage to property resulting from incorrect reassembly, removal or altering of any parts in
any manner.