Manual

with up to 9 rounds. To unload the magazine, push each cartridge forward until it is no
longer held by the magazine lips.
Load your firearm by keeping your finger off the trigger. Insert the magazine in the pistol
by pushing it upward into the magazine well until it is retained by the magazine catch.
Grip the pistol with your shooting hand, keeping the muzzle pointed in a safe direction.
With your other hand, grasp the serrated surfaces at the rear of the slide and pull fully to
the rear then release it promptly allowing it to return on its own. This action will chamber
the first cartridge, cock the hammer and the pistol is ready for firing.
UNLOADING:
Rotate the safety lever up to the “ON” position and remove the magazine by pushing the
magazine catch rearward and pulling the magazine down and out of the frame. Keeping
the pistol pointed in a safe direction, pull the slide back fully to eject the cartridge from
the chamber. Holding the slide back, look in the chamber to ensure the pistol is empty. To
de-cock your pistol, BE ABSOLUTLY SURE THE PISTOL IS UNLOADED AND HAS
NO MAGAZINE INSERTED, then pointing the pistol in a safe direction pull the trigger
to “dry fire” the firearm, now the hammer has been de-cocked.
DISASSEMBLY:
WARNING!
ALWAYS CHECK TO MAKE SURE YOUR PISTOL IS UNLOADED BEFORE
YOU BEGIN TO DISASSEMBLE!
Remove the two screws on the top of the rib by the front and rear sights. Now pull the rib
straight up and off. Disconnect the recoil spring from the slide and the barrel. The slide
can now be lifted up and off the frame. Do not allow the hammer to drop forward when
the slide is removed, as this may cause damage to internal parts. We suggest that you do
not take down this firearm any further than is explained in this manual.
REASSEMBLY:
WARNING!
Excel Industries, Inc. assumes no liability or responsibility whatsoever for injury, death,
or damage to property resulting from incorrect reassembly, removal or altering of any
parts in any manner.
With the hammer cocked, replace the slide on the frame. Reconnect the recoil spring to
the slide and to the barrel. Place the rib on top of the barrel and slide, then replace the two
screws next to the sights.
CARE AND CLEANING: