Service manual

C. Drain Clamp Installation
Choose the drain outlet location.
The following are instructions for discharging
in the sink drain pipe. (Refer to Fig. 1, page 3)
1. Position the Drain Clamp on the sink drain
pipe above the drain trap. Allow room for
drilling. Tighten securely.
2. Use a battery powered or properly
grounded drill. Using the Clamp port as a
drill guide, drill a 7/32" hole through the
wall of the drain pipe. Do NOT penetrate
the opposite side of the pipe.
3. Locate the 3/8" Black Drain Tubing
connected to the Reverse Osmosis Unit.
Route to the tubing to the Drain Clamp and
trim to length.
NOTE: When cutting the polytubing make
clean, square cuts, failing to do so could
result in poor connections and possible
leaks.
CAUTION: The lowest point of the line
should be the point of connection to the
Drain Clamp. There should be no sag in the
line as this may cause excessive noise as
the reject water is flowing to drain.
• Refer to Fig. 4, below. To connect the
Drain Tubing, install the Compression Nut
and the Brass Insert.
• Insert the tubing into the Drain Clamp and
tighten the Compression Nut.
Figure 4
8