Use and Care Manual

5
1. With the Feed Chute facing straight up, insert the Head into the Gear Housing. Line up the
slot in the Head with the Knob/Pin inside the Gear Housing. Be sure the Head is seated fully
into the Gear Housing (Figure 1).
SETTING UP THE APPLIANCE FOR USE
food tray neck
feed chute
food tray
Figure 3
grinder head auger washer auger cutting blade grinding plate grinder head ring nut
Figure 2
down spout
7. Insert the neck of the Food Tray onto the Feed Chute (Figure 3). NEVER operate Grinder
without the Food Tray secured in place.
2. Tighten the Head Locking Knob to lock the Head into place.
3. Insert the Auger, with the Auger Washer attached, into the Head (Figure 2). NOTE: Periodically
inspect the Auger Washer for wear. If the Auger Washer is worn excessively, replace it
immediately or Head damage could result.
4. Place the Cutting Blade onto the end of the Auger - the “pin” side (Figure 2). Be sure the
blades of the Cutting Blade are facing outward.
5. Place one of the Grinder Plates onto the Auger pin; align the notch in the Grinder Plate with
the pin in the Grinder Head.
6. Install the Retaining Ring, DO NOT OVERTIGHTEN. Turn the Retaining Ring until it makes
contact with the Grinder Plate, then make 1/4 turn more to tighten into place.
grinder
head
gear housing
knob/pin
Figure 1
feed
chute