Instruction manual

Attaching the leveling feet
Install the leveling feet as shown. Loosen the upper
and lower nuts as needed to adjust the height
of the foot.
Installing the optional stand
If you prefer an optional stand (item EX-21BS is avail-
able from your local General International dealer.
The stand is equipped with mounting holes allowing
the saw, after removing the leveling feet, to be bolted
directly to the stand.
For your safety it is essential that the machine does not rock or tip during operation. Upon start-up or during oper-
ation, if you notice any rocking, tipping or chattering of the base turn the machine off immediately and readjust
the leveling feet as needed to stabilize the scroll saw on the bench or work surface.
If a permanent shop placement is practical, consider
removing the leveling feet on the base and drilling
matching through holes in the mounting surface of
your workbench or stand to bolt the saw in place
(hardware not included) on your workbench.
If a permanent installation is not practical, clamps
can also be used to secure the saw to a bench or
work table.
a. Saw
b. Hex head bolt
c. Flat washer
d. Workbench or
stand
e. Flat washer
f. Lock washer
g. Hex nut
ORDER OF ASSEMBLY
Mounting to a work surface
Plug the female end of the power cord into the sock-
et at the rear of the saw as shown.
Attaching the pow
er cord
8