Instruction manual

UNPACKING & SET UP

UNPACKING

Carefully unpack and remove the scroll saw and its components from the box and check for missing or damaged

items as per the list of contents below.

Note: Please report any damaged or missing items to your General International distributor immediately.

LIST OF CONTENTS

Once the parts have been removed from the

packaging, you should have the following items:

Qty

SCROLL SAW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

POWER CORD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

LEVELLING FEET WITH NUTS . . . . . . . . . . . . . . . . . . . . .4

ALLEN KEY 3MM . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

BLADE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

INSTALLATION & ASSEMBLY

Before starting the assembly, make sure that the switch is in the “OFF” position and that the power

cord is unplugged. Do not plug in or turn on the scroll saw until you have completed the assembly

and installation steps described in this section of the manual.

Unscrew the 4 shipping bolts and remove the saw from the protective plywood shipping base. For your conven-

ience this scroll saw is shipped from the factory partially assembled and requires only minimal assembly and set-

up before being put into service.

The unit should be installed on a flat, sturdy and

stable surface able to support the weight of the

machine and the workpiece with ease.

Never install the machine over the edge of a table

or workbench.