Specifications

11
INSTALLATION OF THE RESAW GUIDE
The 3 1/2" resaw guide facilitates resawing of wide boards by allowing you to pivot your workpiece on its curved
surface to correct the line of the cut as you push the work piece into the blade .
1. Screw a hex nut onto each of the 2 lock knobs ,
just a few turns only, leaving a good space between
the nut and the knob .
2. Slide the nut/knob sets into the slots on the flat face
of the resaw guide with the nuts on the outside face
as shown above.
3. Slide the resaw guide onto the fence by sliding the
nuts into the slot in the fence, from the rear.
4. Position the resaw guide along the fence, lining up
the center of the guide with the blade of the saw.