Specifications

18 MT410 Controller Reference Guide
!
To connect a keyboard power tap cable:
1. Disconnect the keyboard cable from the back of your computer.
2. Plug the keyboard cable into the power tap cable.
3.
Plug the power tap cable into the keyboard socket on the back of your
computer.
4.
Remove the plastic plug covering the power jack of the 9-pin D
connector on the serial cable.
5.
Connect the DC plug from the power tap cable to the jack built into the
9-pin D connector.
Mounting the Touchscreen
There are several methods for mounting the touchscreen depending on your
application (CRT displays, LCD modules, flat panel displays, each in a
variety of sizes). If you need instructions or recommendations from
MicroTouch on how to incorporate a touchscreen into your OEM design,
you can order the publication Touchscreen Kits Installation Guide
(Document Number 19-215).
Turning On Your System
Before you turn on your custom system, ensure that all cables are connected
properly and that the controller is properly mounted. Be sure to tighten all
cable connector screws.
! To start up your system:
1. Turn on your monitor and computer.
2. Adjust the contrast and brightness to suit your personal preference and
working environment.
3. Adjust the horizontal and vertical position controls on the monitor to
center the image on the screen.
The MT410 controller has a light emitting diode (LED) on the component
side of the board that indicates the status of the touchscreen unit.