Specifications

Excalibur Multirate DAP Installation and Operation
3-26
NMI
EXT
ALM
DED SW56 DL
DTE
POWER
TO AC OUTLET
SNAP-ON
FERRITE
Figure 3-11. Power Supply Connection
Calibration
If your unit is equipped with a Model A or C Aggregate card, you must calibrate the
transmitter whenever the power supply is changed. To perform this procedure,
disconnect the cable from the dedicated line connector, labeled DED. From the front
panel, enter the DAP submenu under the Configuration menu. Press the Accpt button
under the TxCal parameter. When calibration is complete, reinstall the dedicated line
cable.