Specifications

Installing the DAP
3-7
• If the dedicated line outlet is a terminal block, use Cable Part No. 5956-158S.
This cable has an 8-pin plug at one end and four spade lugs at the other end.
Both of these cables are provided with your DAP. Figure 3-4 shows both types of
dedicated line connections. Table 3-3 lists the pin/signal assignments for the DED
connector. (The leftmost pin is designated pin 1.)
SPECIAL NOTICE
Important governmental requirements are listed in the front of this manual. In order to
comply fully with the rules of the government, carefully read these instructions before
connecting to the telephone line, and where applicable, follow them completely.
USE CABLE 5956-149G
WHEN DEDICATED LINE
TERMINATION IS 8-PIN
JACK
USE CABLE 5956-158S
WHEN DEDICATED LINE
TERMINATION IS TERMINAL
BLOCK
NMI
EXT
ALM
DED SW56 DL
DTE
POWER
Figure 3-4. Dedicated Line Connection