Specifications

On-Line Operation
6-23
The following messages are generated when the DAP rejects an incoming call of an
incompatible type. For example, calls from conventional telephones, calls from units
equipped with Switched 56 IDBU when the dial mode parameter is not set to ESw56, or
calls from units equipped with ISDN IDBU when the dial mode parameter is set to
ESw56.
ISDN Status Speech Call Rejected ISDN Status 64 kbps Call Rejected
ISDN Status 3.1 kHz Call Rejected ISDN Status Incompat. Call Rejected
ISDN Status 56 kbps Call Rejected
The following messages are generated when Progress Indicator Information Elements are
received from the network. The progress value number is the Progress Descriptor value
received in the Progress Indicator Information Element. The associated text is a
paraphrase (edited to save space) of the formal definition for that value. Values from 1
through 10 are defined by CCITT standard Q.931. The other values are from the
National standard and/or are network specific.
ISDN Progress 1 Not End-to-End ISDN Call ISDN Progress 17 Treatment Applied To Call
ISDN Progress 2 Destination Is Non-ISDN ISDN Progress 18 Call Proceeding
ISDN Progress 3 Origination Is Non-ISDN ISDN Progress 19 Alerting At Destination
ISDN Progress 4 Call Returned To ISDN ISDN Progress 20 Connected at Destination
ISDN Progress 8 In Band Info/Pattern ISDN Progress 21 Dialing
ISDN Progress 10 Unit Could Not Answer ISDN Progress 22 Disconnect
ISDN Progress 16 No Response, Reattempted
Viewing Stored Alarms
The Excalibur Multirate DAP contains an alarm buffer that stores reported alarms. To
view these alarms, follow these steps, starting from the Top Level menu:
1. Press the 1 or 2 button depending on which DAP's (local or remote) alarms you
wish to view.
Note: Monitoring remote alarms is interruptive when the service is set for DDS.
1 234
Escape
Top
T
E x c a l i b u r D A P
L o c a l R e m o t A d d r s S e r v e >
<
>