Specifications

Defining Operating Parameters
5-33
Table 5-11. RCP Parameters
Parameter Possible Settings
Controller
1
(Cntrl) No, Yes
RTS Mode (RTSMd) Constant, Switched
DCD Mode (DCDMd) Constant, Switched
Secondary Channel Format
2
(SCFmt) Excalibur, 1500, 1556, DSU-RD
Local Diagnostics
3,4
(LDiag) Enabled, Disabled
Remote Diagnostics
3
(RDiag) Enabled, Disabled
Alarm Detection (AlmDt) Disabled, Enabled
Local Alarm Display (LAlmD) Disabled, Enabled
Analog Regeneration (AnaRg) Enabled, Disabled
Digital Regeneration (DigRg) Enabled, Disabled
Diagnostic Compatibility (DiagC) On, Off
Route Secondary Channel
5
(RoutS) To Dial, With Data
1. This parameter does not appear on the screen when the Clear Secondary Channel
parameter is enabled.
2. This parameter appears on the screen only when the service is set for DDS, DDS-
SC, or LDM. It does not appear for DDS-SC or LDM when the Clear Secondary
Channel parameter is enabled. The unit defaults to Excalibur.
3. This parameter appears on the screen only when the service is set for DDS.
4. This parameter does not appear on the screen if the unit is set for a remote unit in
a multipoint network.
5. This parameter appears on the screen only for units equipped with the Analog or
ISDN IDBU option.
The following sections describe each of the RCP parameters.