Installation manual

Do not use a pipe wrench to tighten Value Iron Filter - Sulphur Filter
nuts on installation fittings. Hand tighten only.
Value Iron Filter - Sulphur Filter split ring retainer holds the nut on
and allows load to be spread over the entire nut surface area
reducing the chance for leakage with the Value Iron Filter - Sulphur
Filter. The split ring design, incorporated into the Value Iron Filter -
Sulphur Filter installation fittings allows approximately 2 degrees off
axis alignment to the plumbing system. The Value Iron Filter -
Sulphur Filter installation fittings are designed to accommodate minor
plumbing misalignments.
Value Iron Filter - Sulphur Filter control valve slip the nut onto the
fitting first, then the split ring second and the o ring last. Hand tighten
the Value Iron Filter - Sulphur Filter nut. If the fitting is leaking,
tightening the nut will not stop the leak. Remove the Value Iron Filter
- Sulphur Filter nut, fitting and check for damage or misalignment of
the o ring.
BYPASS VALVE:
The Value Iron Filter - Sulphur Filter bypass valve easily connects to
the Value Iron Filter - Sulphur Filter control valve body using nuts that
only require hand tightening. Hand tighten nut connections between
Value Iron Filter - Sulphur Filter control valve and fittings, Value Iron
Filter - Sulphur Filter control valve and bypass valve Value Iron Filter
- Sulphur Filter and installation fittings allow for easy serviceability.
On Value Iron Filter - Sulphur Filter do not use Vaseline, oils or other
unacceptable lubricants on o- rings. A silicon lubricant may be used
on Value Iron Filter - Sulphur Filter black o rings. All seals are self
lubricating EPDM for long life lubricating qualities.
Check Valve Installation
The one way Value Iron Filter - Sulphur Filter check valve supplied
with the Iron Filter - Sulphur Filter must be installed on the raw water
supply feed line prior to entering the Value Iron Filter - Sulphur Filter.