Service manual

C. Reverse Osmosis Drain Clamp Installation
Choose the Reverse Osmosis drain outlet
location.
The following are instructions for discharging
in the sink drain pipe. (Refer to Fig. 1, page 3)
1. Position the Drain Clamp on the sink drain
pipe above the drain trap. Allow room for
drilling. Tighten securely.
2. Use a battery powered or properly
grounded drill. Using the Clamp port as a
drill guide, drill a 7/32" hole through the
wall of the drain pipe.
3. Locate the 3/8" Black Drain Tubing
connected to the Reverse Osmosis System.
Route to the Reverse Osmosis tubing to the
Drain Clamp and trim to length.
CAUTION: The lowest point of the line
should be the point of connection to the
Reverse Osmosis Drain Clamp. There
should be no sag in the Reverse Osmosis
tubing as this may cause excessive noise as
the reject water is flowing to drain.
• Refer to Fig. 4, below. To connect the
Drain Tubing, install the Compression Nut
and the Brass Insert.
• Insert the tubing into the Drain Clamp and
tighten the Compression Nut.
Figure 4
8