Installation manual

place screwdriver in slots on caps and/or tap with a hammer as this
could damage the Premium Water Softener
WATER SOFTENER INSTALLATION SITE
REQUIRMENTS
• Water pressure 20 – 125
psi
• Current draw is 0.25 amps
• Water temperature 5 to
30°C or 40 to 100°F
• A 15 foot power cord is
furnished
• The Water Softener tank
should be on a firm level
surface
• The plug-in transformer is
for dry location only
• Electrical use of 115/120
volt 60 Hz uninterrupted
outlet
• Batteries are not used
1. The distance between the Premium Water Softener and the
water drain should be as short as possible. When installing
your Premium Water Softener all plumbing must be done in
accordance with local plumbing codes. The Water Softener
must not have a piping header that exceeds 3 meters (10
feet).
2. Since water softener salt must be used periodically and be
added to the Water Softener, the brine tank should be
located where it is easily accessible.
3. Do not install your Premium Water Softener with less than
10 feet of piping between your Water Softener and it’s
electrical outlet and the inlet of the water heater.