User`s manual

Chapter 3 Interface Information
www.exatron.com 3/19/01
3-18
C
OMMANDS FROM THE
PC
TO THE
H
ANDLER
:
1 [CR] = SORT 1
2 [CR] = SORT 2
3 [CR] = SORT 3
4 [CR] = SORT 4
5 [CR] = SORT 5
6 [CR] = SORT 6
7 [CR] = SORT 7
8 [CR] = SORT 8
+
(plus) = Put handler in Listen mode.
+ A90 [CR]
= Ask handler to send a specific EPROM/RAM address setting:
“
?? ROM ?? RAM ??
”
+ B [CR]
= Reset all handler tube/total counters to zero.
Handler display will read,
TOTALS SET TO 0
.
+ C90 FF [CR]
= Accept new RAM settings from PC.
+
= plus
C
= “C” command
90
= address
= space
FF
= new data for address location
[CR]
= end of string
+ D [CR]
= Loads handler EPROM default settings into the handler’s RAM address,
from 0090-00FF to E390-E3FF.
Handler display will read:
LOAD EPROM > RAM
.
+ E [CR]
= Send EPROM/RAM address “labels”
+ F [CR]
= Send RAM data from handler to PC. Handler returns a long string of 8 bit
characters, one character for each address location from E390 to E3FF, ending
with a [CR].
+ G [CR]
= Go; Index a new DUT, start running operations.
+ I [CR]
= Handler returns EPROM default settings addresses 0090 - 00FF.
+ P [CR]
= Pause the handler. Press the handler
RUN
button to restart operation.
+ T [CR]
= Send RAM data from PC to handler RAM E390 - E3FF.