User`s manual

Chapter 3 Interface Information
www.exatron.com 3/19/01
3-3
Stop On Fail Y/N: Address 00AA
30 = Stop on Fail
FF = Run Failed Devices, No Stop
This option allows the handler to Stop on Fail, or not. The handler can either automatically cycle a failed
device into an output tube or the handler can be set to stop. If set to
STOP ON FAIL YES
, then the
handler will stop on a failure and allow the operator to retest the device again and again, as often as
desired. This is very useful when calibrating test fixtures and programs.
Double Test Sort: Address 00BC
This address tells the handler which test sorts to double test if desired. A setting of “
00
” will turn
off
the
double test for all sorts. A setting of “
FF
” will set the tester to double test
all
devices. Assuming Sort 1 is
Pass and all other sorts are to be double tested, set this address to “
FE
.” Each bit represents a tester
sort.
Tester Sort Set Up: Addresses 00C0 to 00C7
ASCII I
NPUT
S
ORT
O
UTPUT
B
INS
C
URRENT
S
ETTING
1
1 RAM ADDRESS C0
2
2 RAM ADDRESS C1
3
3 RAM ADDRESS C2
4
4 RAM ADDRESS C3
5
5 RAM ADDRESS C4
6
6 RAM ADDRESS C5
7
7 RAM ADDRESS C6
8
8 RAM ADDRESS C7
✻
✻✻
✻
= Remote Flush
USED BY EXATRON RS
-
232
AND H P RS
-
232 ONLY
0
= Remote Retest
USED BY EXATRON RS
-
232
AND H P RS
-
232 ONLY
The handler uses the specifications shown in the table above to assign Output Bins to tester Sorts.
The “Current Setting” column is provided for the customer’s reference purposes. Please enter your
settings in this column.
If the handler does not receive one of the above test Sorts, the handler will pause and display the
message, “
BAD TEST RESULT
.” The handler will output the HEX equivalent of the actual character
received by the handler to the LEDs on the handler’s output shuttle cover. LED #1 is bit 01, LED #8 is bit
80. Pressing the
[Clear]
button on the handler’s front panel will flush the device from the test site and
restart operation. Press
[Enter]
to retest, if desired.
When the handler does receive a proper result in the form of one of the above test Sorts, the handler will
open the test contacts and flash the output cover LED of the output bin selected. The handler will sort the
DUT accordingly and start a new handling cycle.