User`s manual

Chapter 2 Handler Setup
www.exatron.com 3/19/01
2-5
STOP ON FAIL ?
[1]
key chooses
YES
[2]
key chooses
NO
[Clear]
key rejects selection and returns to
STOP ON FAIL ?
[Enter]
key accepts selection and exits Setup mode.
The system is now ready to run parts.
RESET TOTALS NO
The handler maintains certain counts relating to the number of parts processed, etc. These counts are
stored in the RAM of the handler controller. Choosing this option will zero out these RAM counts, but will
not effect any of the RAM settings which can be set by the
CHANGE RAM?
option described later in this
chapter.
First make sure the display reads:
READY TO RUN
Depending on the status of the handler the display may also read:
EMPTY/LOAD PARTS
or
EMPTY ALL TRACKS
The yellow light on the lightpole will be lit.
Now press the
[SET UP]
key on the microterminal.
The display will read
CHANGE RAM? NO
.
Press
[Enter]
.
The display will read
RESET TOTALS NO
.
[SET UP]
key toggles to
RESET TOTALS YS
.
[Enter]
key accepts reset command, briefly displays the message
TOTALS SET TO 0
, then
moves to
MOD SET UP ? NO