User`s manual

Chapter 2 Handler Setup
www.exatron.com 3/19/01
2-2
whether to change any of the setup parameters of the handler, and it proposes the answer no. It is
possible to toggle the answer to such questions, and then accept those changed answers.
Also, any text within brackets
[ ]
indicates a key on the microterminal.
Example:
[Enter]
means to press the enter key.
Any messages on the display will be printed in reverse video.
Example
:
READY TO RUN
EXAMPLE OF MICROTERMINAL
STARTING THE SETUP PROCEDURE
METHOD 1
Use this method when the handler is already powered on.
First make sure the display reads:
READY TO RUN
Depending on the status of the handler the display may also read:
EMPTY/LOAD PARTS
or
EMPTY ALL TRACKS
The yellow light on the lightpole will be lit.
Now press the
[SET UP]
key on the microterminal.
The display will read
CHANGE RAM? NO
.
Press
[Enter]
.
The display will read
RESET TOTALS NO
.
Press
[Enter]
again.
The display will read
MOD SETUP NO
.
The
[SETUP]
key will toggle between
MOD SETUP NO ?
and
MOD SETUP YS ?
Press the
[SETUP]
key to change the display to
MOD SETUP YS ?
Press the
[Enter]
to start Modification Setup.
Now proceed with the instructions under the heading
MOD SETUP YS ?
later in this chapter.