Owner`s manual

Start playback. You will see the level indicators moving and the current sampling rate displayed on the
exaSound Dashboard. The e28 DAC front panel display will indicate the stream format (PCM or DSD), the
sampling rate and the master volume level.
Note: level indicators are inactive in DSD mode.
Volume Bypass
When the volume sliders for the exaSound driver in the Audio MIDI Setup application are set to 0dB, the
hardware volume control is turned off and the e28 DAC operates in Volume Bypass Mode.
To activate Volume Bypass:
• Set the master volume slider to 0dB.
• Set the left and right volume sliders to 0dB.
• Make sure that your player is not changing the volume level.
JRiver / JRemote Volume Synchronization Plug-in
The exaSound Volume Synchronization Plug-in allows JRiver 20 for Windows and JRemote to access the
hardware volume control built in all exaSound DACs.
• Moving the JRemote or JRiver volume slider changes the master volume slider on the exaSound
Dashboard.
• Changing the master volume with the exaSound Dashboard adjusts the JRemote / JRiver volume
sliders.
Check the Guides section of the exaSound Blog for step-by-step configuration instructions for the
exaSound Volume Synchronization Plug-in:
exasound.com/Blog.aspx.
Page | 22