Owner`s manual

Page | 13
Remote Control Setup
The e18 DAC is pre-programmed to work with the supplied remote control. If you like, you can
reprogram the e18 DAC to work with a different IR remote control. The exaSound e18 DAC can be
trained to recognise commands from most infrared remote controls using Sony and NEC IR protocols.
Use the following procedure to change remote control button assignments or to pair the e18 DAC with a
different remote control:
1.
Power on the e18 DAC. Make sure that the unit is not in
playback mode.
2. Press the Setup button.
3.
Press the
Volume Up
button to conf
i
rm the remote control
programming mode, or press the Volume Down button to
cancel the operation.
4.
Point the remote control to the e18 DAC display.
P
ress and hold
down the remote control buttons for about one second during
each step below to assign functions to them.
5. Press the remote control button you want to use for increasing
the volume.
6.
Press the remote control button
you want to use for
decreasing
the volume.
7.
Press the remote control button
you want to use fo
r
selecting
the next input.
8.
Press the remote control button
you want to use for
previous
input.
9.
Press the remote control button
you want to use for
turning the
unit on and off.
10.
Press the remote control button
you want to use for
mute
.
11.
Wait
until the remote control configuration is saved. Your e18
DAC is now paired for with the new IR remote control.