User's Manual

Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
84 209866-002
2015-09-09
Regulatory Notices
This section presents the Regulatory Compliance Regulations for your country.
United States Compliance
The ExtendAir G2 24GHz product family operates under FCC Rule Parts 15.249 as a un-licensed device.
They may only be used as a point-to-point transmission device for fixed or temporary-fixed (non-
mobile) installations. The devices are subject to the following restrictions:
• Do not use external amplifiers to boost the power or overcome transmission system losses, unless
the specific amplifier/cable/antenna combination has expressly been authorized by the FCC.
• Cross-border transmissions are expressly prohibited, except with written permission from both
the
FCC and the governing body of the neighboring country (Cofetel for Mexico; Industry Canada for
Canada).
• Use only parabolic dish antennas. No other types of antennas (omni-directional, yagi, and so on)
are authorized.
Federal Communications Commission (FCC), United States
The device is allowed to be used provided it does not cause interference to other devices. It is not
guaranteed to provide protection against interference from other electronic and radio devices.
The system has been tested and found to comply with the limits of a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
regulations.
Changes or modifications not expressly approved in writing by Exalt may void the user’s authority to
operate this equipment.
This device must be professionally installed.
To comply with regulations, the output power of this device may need to be adjusted in accordance to
the associated transmission system. See RF Output Power Setting
for details.
This device complies with Part 15 of the FCC Rules. Operations is subject to the following two
conditions: (1) this device may not cause harmful interrference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.