User's Manual
Table Of Contents
- ExtendAir® G2™ 24GHz Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- SSH or Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zones Configurations Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- ATPC Configuration Page
- Alarms Page
- Performance Page
- ATPC Statistics Page
- Ethernet Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
ExtendAir G2 24GHz Digital Microwave Radios
209866-002 61
2015-09-09
User Throughput Page
This page illustrates the user throughput of the radio, as configured. This value is calculated based on
the current configuration, not on a specific setting or the measured current throughput.
Figure 35 User Throughput page
Click the help icon ( ) to go to the page on how this information is determined (Figure 36).